Authors
M. Rizon1, *, C.K. Ang1, Mahmud Iwan Solihin1, Zuradzman Mohamad Razlan2,
Hazy Desa2, Shahriman A. Bakar2, Wan Khairunizam2, Zunaidi Ibrahim3
1Faculty of Engineering, Technology and Built Environment, UCSI University,
Cheras, Kuala Lumpur 56000, Malaysia
2School of Mechatronic, University Malaysia Perlis (UniMAP), Arau, Perlis
02600, Malaysia
3Faculty of Technology, University of Sunderland, St Peter’s Campus, Sunderland
SR6 0DD, UK
*Corresponding author. Email: [email protected]
Corresponding Author
M. Rizon
Received 4 November 2019, Accepted 16 April 2020, Available Online 3 June
2020.
DOI
https://doi.org/10.2991/jrnal.k.200528.004
Keywords
UAV; quadrotor; moment of bending; arm length
Abstract
Quadrotor is a type of unmanned aerial vehicle that has been widely used
in many applications, such as, policing, surveillance, aerial photography
and agriculture. Conventionally, the control of quadrotor flight direction
is accomplished by varying speeds of rotors or manipulating torques. In
this paper, a novel mechanism is proposed. The mechanism uses stepper rotors
to control the arm length for changing flight directions, while maintaining
rotors’ speed at constant. This can be achieved using a mathematical analysis
of relation between quadrotor arm length and moment of bending of various
position of rotor. Analysis and simulation results have shown the change
in arm length required to produce moment of bending for hovering, roll
and pitch motion. Experimental results have shown that the new mechanism
is able to carry more payloads which the rotor speed can be utilized fully
at 100% while the flight direction is been controlled by changing of the
arm length compared to conventional flight control mechanisms.
Copyright
© 2020 The Authors. Published by ALife Robotics Corp. Ltd.
Open Access
This is an open access article distributed under the CC BY-NC 4.0 license
(http://creativecommons.org/licenses/by-nc/4.0/).